Safedisc251, CloneCd and Mitsumi Drive

S

Spakker

1
Hi,
I posted last week about CloneCd profiles, i've managed to understand a little bit more about 1:1 copies, but there are a few settings i'm not sure about. 10 failures so far.

Game is SDv2.51 Protected (I do own it btw!)
Burner is Mitsumi 485CTE (40x20x48) Latest Firmware.
According to CloneCD's site it can do everything (EFM, DAO96 etc)

How should the following be set?

***READING THE DISC***

Allow Reading of Subchannel data/audio?
CD-text?
Fast Error Skip - Retries? And Error Correction?
Regenerate Bad Sectors?
Error Handling?

I have generated a profile based on SD2.51 from ClonyXXL 2006 and it writes a nice cd, although it doesnt work perfectly.

As far as writing the disc goes, I think i've got it covered, no obvious mistakes noted.

I hope someone can shed some light on these additional settings and maybe about my burner, thanks a lot.

SPK.
 
VIPER_1069

VIPER_1069

1
use the search button here and find the clone cd profiles and use those there preset to handle all the protections out there that can be copied !! ;)
 
S

Spakker

1
Thanks for the link, it was really useul, much appreciated.

I found out the game i'm trying to back up has Safedisc 2.6xxxx protection, so my Mitsumi cant reproduce the disc.
I can make a copy that will install, but not play.

After reading up on other websites, i'm 100% confident tha t my burner can do everything else, except SD2.6.

If anyone else has any thoughts please post here.

Thanks again, as always!

Spk.
 
daveml

daveml

1
I have a mitsumi drive, but I dont copy games.
I have no problems with anything else though.
up to now!
 
You must log in or register to reply here.
Top