problem with clonecd 4.0.1,3

[canny]

I've just install ccd 4.0.1.3 and reg it with the damn keygen (the 3.0.4.2) the registration goes fine but when i tried to burn something after the reading and just before to write an error message say:
ILLEGAL REQUEST: COMMAND SEQUENCE ERROR (5:0x2c:0x00)

Does someone knows if it is a keygen problem or something else?

 

[canny]

I have a Plextor 2410A , and before installing ccd 4 I had the version 3.3.4.1 and everything was ok, maybe there's something wrong in the settings but i don't know where to find.
One more thing, I only have try in the simulation mode, 'cause
i have'nt a real need to burn something by now, could it be the reason?

thank you for the help

canny

 

[canny]

but i read between the new features of ccd4 the add of the simulation mode for plextor writers. do you think that doesn't work anyway?

 

[Master]

I don´t own a plex but i know that the simulation feature of blindwrite was disabeled because the Plextor drives can´t do a simulate writing with Raw-Dao.

 

[netman]

bite the bullet and burn something for real. that will tell you if it's just the simulation or a problem with clone.

 

[Gargamel]

but i read between the new features of ccd4 the add of the simulation mode for plextor writers. do you think that doesn't work anyway?

Yes, for very recent drives. Yours is not old, but maybe this model doesn't support the feature. Mine does not work, anyway.

 

[Gargamel]

Re: Gargamel

Hmmm ... welcome to you too (??)

Yes, I was speaking about the simulation feature, that is not available in CCD with a lot of Plextor drives.