where is the mistake?
i have installed maestro 2813. during the installation are some error-messages because of not installed hardware. i have no SIGMA-CARD and so on.
after Re-Boot maestro works, but my computer doesn't shut down. every time the pc says goodby with a blue-screen and the error-message "DRIVER_POWER_STATE_FAILURE".
when i try to re-boot, the error-message (blue-screen) comes back. only the RESET-button can help.
this suckz.
can anybody help.
is this possible, that i have bull-shit maestro-version ?
my system:
winXP pro
athlon XP1700+
256 MB RAM
NTFS
1x HD 20 GB primary IDE master (system with maestro)
1x HD 60 GB primary IDE slave
(sorry for my english)
digidelic
i have installed maestro 2813. during the installation are some error-messages because of not installed hardware. i have no SIGMA-CARD and so on.
after Re-Boot maestro works, but my computer doesn't shut down. every time the pc says goodby with a blue-screen and the error-message "DRIVER_POWER_STATE_FAILURE".
when i try to re-boot, the error-message (blue-screen) comes back. only the RESET-button can help.
this suckz.
can anybody help.
is this possible, that i have bull-shit maestro-version ?
my system:
winXP pro
athlon XP1700+
256 MB RAM
NTFS
1x HD 20 GB primary IDE master (system with maestro)
1x HD 60 GB primary IDE slave
(sorry for my english)
digidelic