help with nero 6 ultra and hp300i

[Punks123]

i just format my computer about 3 month ago and has no try my hp300i. so i did burn it using nero at 16x it work fine but when i select lower speed it burn about 30, 60 or even at 95 percent then it said fail. i try to reinstall the nforce driver but it not help i try the aspi 4.7 but it seem to have the same problem. i try with alcohol 120 and it work great at 16x but fail in lower speed. i have nero 6, alcohol 120, stomp, winiso install. it work at all speed b4 i format it so i dont know if there any conflict that happend between it or so.


i reinstall the 4.71 aspi. i;m using the 2.45 nforce,i just unistall the 2.45 and put back in the 2.03 same thing. i update the firmware to 1.29 but problem is still there. also i try to install back nero 5.5 but it did not solve the problem.

also i just reinstall nero 6 ultra how come it does not have the multiple cd burner box, can some one tell me why or where can i find it?


please help

 

[scarecrow]

Nero does not need ASPI, and your PC does not need ASPI 4.7X- quite the opposite. Version 4.60.1021 (or maybe 1019) is still the best bet.
Nero 6 has loads of problems, 5.5.10.42 should work much better.
The "mulitiple burner box" is not an option for a regular retail Nero version (only 1 burner at a time supported), unless you have purchased a special Nero licence and you are not aware of that fact...

 

[Punks123]

ok so should i turn my aspi back to 4.6 or leave it as it? as for the problem i finally fix it, reading through some thread and found the nero cleaner. i try it and reinstall the the nero 6.009 and then update it to 15 and it work. i could burn multiple recorder and the speed problem has been solve. i could able to burn at 8x without any failing message. althrough i only try it 2 time at 8x and 2 time at 16x. do you think that it should work ok now?

BTW thank for anwer my post

 

[scarecrow]

Nope, you are not OK.
4.7X is a potential troublemaker and Nero6 (unlike nero 5.5) has issues with Stomp/RNM in most cases (just hope you are the bright exheption).
You can keep pushing your luck, but IMO the switch from ASPI 4.7X to 4.60.1021 is mandatory (use forceASPI 1.8 to remove your current layer, and then forceASPI 1.7 to install 4.60.1021- both are freeware and widely available, eg from filemirrors).