HELP!!-Need program for Neato 3 UP CD label printing

I recently purchased a bunch on Neato 3 up glossy CD labels. I have been using SureThing for about 4 years and currently have 3.11 retail from the full ISO installed. It looks like I will have to abandon using SureThing for these labels since there appears to be a margin across the bottom of the page that is visible in print preview that cuts about a half an inch off the bottom label. I can in no way figure out how to adjust that margin. Sure enough when you print it, the bottom sticker is white across the bottom. A little bit of the top left sticker gets cut too. Any ideas would be greatly appreciated.

So I got Neato Mediaface 4.0 SP2 thinking that would be the easy answer. This program appears to have a steep learning curve. I can't figure out how to print 3 different labels on the same sheet in one print job.
 
Why don't you make a template of your own for them in Surething?... although the problem may be with your printer, and not the application.
 
Last edited:
Thanks guys for your suggestions.

I started to make a new template, but it was too tedious. I have since discovered that it appears to be my printers. I have an HP Photosmart P1000 and several other HP printers. They apparently do not print photo quality images below a 1/2 inch bottom margin. So in Surething under file ->page set up, I elected to flip the template. So now the bottom left sticker is in the upper right hand corner. I can now print on those labels. It takes two print jobs to do a whole sheet, but it is better than trashing them.
 
Top