I seem to be in a loop. Every time I start ClonyXXL, it keeps asking about the drive letters (after loading an older English translation, I eventually figured out what it was asking at least), but I keep assigning the drive letters to the correct numbers, and hit apply, then it says "Restart ClonyXXL". I hit OK, open it back up, and I'm at the same place. I had it working once before, but it refuses to now. Any ideas?
ClonyXXL
- Thread starter Jito463
- Start date
Hmm, it's not, but I think I might know the problem since I looked at it again. I recently installed the latest Nvidia SW IDE drivers, which makes all drivers appear as SCSI. I wonder if that's confusing ClonyXXL. Should I try editing the clonydrives.ini and where it has =0 =1, etc put =P =Q, etc?