Clone cd help needed

Strix · Mar 13, 2003

When i try to burn a image i get a error on the image sub can i burn the file with any other softwere?? Or how can i correct it??

Strix · Mar 13, 2003

Image.sub not correct with image.img

scarecrow · Mar 13, 2003

Did you use something like Winiso to manipulate the CloneCD image?

Strix · Mar 13, 2003

No

i just downloded the image files and tryinig to burn it down on a cd. Do you know any sofware to unpack the files so i can install it from my computer??

domer · Mar 13, 2003

Sorry, but what to do, if I have used WinISO soft to edit .img file? Is it able to burn edited image? I have one edited image, and it seems to run with ElBy Virtual DVD.

scarecrow · Mar 14, 2003

The downloaded image should be corrupt.
After using Winiso you most likely have destroyed the Clone imagefile (image and sub mismatch and such), but you could also have faith to your good luck...

topcad · Mar 14, 2003

You can try to load the image into a virtual cd drive if this works then you can burn it like you copy a cd to a cd.

Greetz,
topcad

domer · Mar 18, 2003

So, if I am using it succesfully with Elby Virtual drive, it can be burned, as I understand you, topcad, right?

topcad · Mar 19, 2003

That's right. I have experience'd some problems like this before and it work'd great.
There was another user who had almost the same problem at a other forum and it work'd by him to.

So good luck.

Duracell · Mar 19, 2003

domer said:
So, if I am using it succesfully with Elby Virtual drive, it can be burned, as I understand you, topcad, right?

mount the image in your Elby Virtual drive;
then use CloneCD and do a 1:1 copy with the vitual drive as reading device;
if your downloaded image is a protected game or protected software, than choose the "Game CD" profile otherwise the "Data CD" preset;

Greetings from
Duracell