Clone cd help needed

[Strix]

When i try to burn a image i get a error on the image sub can i burn the file with any other softwere?? Or how can i correct it??

[Strix]

Image.sub not correct with image.img

[scarecrow]

Did you use something like Winiso to manipulate the CloneCD image?

[Strix]

i just downloded the image files and tryinig to burn it down on a cd. Do you know any sofware to unpack the files so i can install it from my computer??

[domer]

Sorry, but what to do, if I have used WinISO soft to edit .img file? Is it able to burn edited image? I have one edited image, and it seems to run with ElBy Virtual DVD.

[scarecrow]

The downloaded image should be corrupt.
After using Winiso you most likely have destroyed the Clone imagefile (image and sub mismatch and such), but you could also have faith to your good luck...

[topcad]

You can try to load the image into a virtual cd drive if this works then you can burn it like you copy a cd to a cd.

Greetz,
topcad

[domer]

So, if I am using it succesfully with Elby Virtual drive, it can be burned, as I understand you, topcad, right?

[topcad]

That's right. I have experience'd some problems like this before and it work'd great.
There was another user who had almost the same problem at a other forum and it work'd by him to.

So good luck.

[Duracell]

Originally posted by domer
So, if I am using it succesfully with Elby Virtual drive, it can be burned, as I understand you, topcad, right?

mount the image in your Elby Virtual drive;
then use CloneCD and do a 1:1 copy with the vitual drive as reading device;
if your downloaded image is a protected game or protected software, than choose the "Game CD" profile otherwise the "Data CD" preset;


Greetings from
Duracell